My ClickBD
Description: Smart Pump Controller will automatically START the-water-pump as soon as the water level falls below the predetermined level and it will SWITCH OFF the-water-pump as soon as the tank is full. Smart Pump controller ensures no overflows or dry running of pump there by saves electricity and water. This device will show overhead_water_level, reservoir_water_level and Pump_status on its LCD display. Some extra feature makes this controller SMART. Test_mode and regular_mode. **During Test_mode the device continuously check the water level after 30 seconds. So it decrease installation time. **In Regular_mode the device continuously check the water level after 3 minute. So it Increase the life time of water sensors. **During failure or disconnect of overhead water sensor the device stop the pump after reach to avg_run : min (max run time) **The device also show real time signal from the tank, Total ON/OFF of PUMP, Last Running Time, Total Running time. Specification: Technical Information: 1. Applicable for home/ office/ industry and more. 2. Single phase 220v AC. 2200watt max load. 3. Size :17cm X 12cm X 4cm, 300gram. 4. Internal voltage : 5vDC, 12vDC and 220vAC 5. Water sensor Voltage : 5v. 6. ON/OFF switch for manual control. 7. 16x2 LCD display. 8. Five step water level display On LCD. 9. Internal 30A Relay, N/O, N/C. 10. Control by atmega8 Micro-controller. features and advantages: 11. Fully automatic and Easy installation. 12. Dual Tank monitoring (overhead + reservoir). 13. Ensure no overflows or dry running. 14. Max Run time limit facilities.(Max:255 minute) 15. Total Run time Counting.(Max:25599 Hours) 16. Number of total Start/Stop Count.(max:9999) 17. Last Run time Show in minute and second. 18. Sensors and cable status show. 19. one year guarantee. |